商品情報にスキップ
1 2

Number7 Racing Products

Dry Carbon Banner Plate ドライカーボンバナープレート

Dry Carbon Banner Plate ドライカーボンバナープレート

2 レビュー数の合計

通常価格 ¥16,500 JPY
通常価格 セール価格 ¥16,500 JPY
セール 売り切れ
税込。 配送料はチェックアウト時に計算されます。
タイプ
車種

※商品画像2枚目 上部-平織、下部-綾織

・ハコスカ用
・S30用
・R32用
・他各種

取り付け方
このプレートの取り付けには接着剤は使用しません。
カーボンプレートの反発力でフロントガラスに取り付けられます。
プレートは少し大きめに作られています。
まずはフロントガラスにフィットさせてみてください。
次に、Aピラーとルーフの隙間に押し込んでください。
車種によってはシリコンゴムがフロントガラスからはみ出ている場合がありますので、ご確認ください。
その場合は、はみ出しているシリコンを取り除く必要があります。
ピラーとルーフの隙間に押し込むのがおすすめです。
プレートをピラーとルーフの隙間に押し込みます。
中央に曲がりがある場合は、プレートをカットしてください。
プレートは丈夫なハサミでカットできます。
カットする場合はプレートの両端をカットしてください。
小さく切りすぎるとカーボンプレートの反発力が失われ、正確に取り付けることができなくなりますので注意してください。
カーボンプレートの反発力で固定されていることをご理解ください。

How to install it. 
No adhesives are used to install this plate.
It is attached to the windshield by the repulsive force of the carbon plate.
The plate is made a little large.
First try to fit it to the windshield.
Then, push it into the gap between the A-pillar and the roof.
Depending on the vehicle, the silicone rubber may be protruding from the windshield, so please check.
In that case, you will need to remove any silicone that is protruding too much.
It is a good idea to push it into the gap between the pillar or roof.
Push the plate into the gap between the pillar or roof.
If there is any bending in the center, cut the plate.
You can cut the plate with strong scissors.
The cuts should be made at both ends of the plate.
Be careful not to cut it too small, as the repulsive force of the carbon plate will be lost and it will not be possible to install it accurately.
Please remember that it is fixed in place by the repulsive force of the carbon plate.

ハコスカ装着例

 

S30Z装着例

詳細を表示する

Contact form